RAYMARINE ST1000 MANUAL PDF

.

Author:Dailrajas Goltinris
Country:Jamaica
Language:English (Spanish)
Genre:Marketing
Published (Last):13 April 2016
Pages:408
PDF File Size:9.33 Mb
ePub File Size:14.83 Mb
ISBN:886-6-75047-478-5
Downloads:31770
Price:Free* [*Free Regsitration Required]
Uploader:Dutilar



Then read through the following information and the relevant installation sections in this chapter. EMC installation guidelines All Raymarine equipment and accessories are designed to the best industry standards for use in the recreational marine environment. If the ferrite needs to be removed during installation it must be reassembled in the same position.

EMC suppression ferrites We supply the fluxgate compass and power cables with suppression ferrites fitted. Always use these ferrites supplied by Raymarine. Measuring the critical dimensions The tiller pilot is mounted between the tiller and a fixed point on the structure of your boat.

Mark dimensions A and B and use masking tape to locate the fixing points. Note: For standard installations, dimension A is measured on the starboard side of the cockpit.

If you need to mount the tiller pilot on the port side of the cockpit, you can measure dimension A to port. Use a two part epoxy e. Araldite to fix the tiller pin in place. Position the shoulder of the pin so it is Installing the mounting socket 1. Drill a Select the appropriate pushrod extension length and part number using the following table. Dimension C Pushrod extension length L Part no.

Identifying the correct tiller bracket 1. Measure dimension D if the pushrod is above the tiller or dimension E if the pushrod is below the tiller. Position the tiller bracket on the center line of the tiller above or below and establish the critical dimensions A and B Note: To measure dimension B on a boat with a sloping rudderstock, refer to the diagram on page Mark the centers of the two bracket mounting holes.

Refer to the table to establish a cutting length for the cantilever rod — double check measurements before cutting. Measure the rod from threaded end, then cut the cantilever rod to length L using a hacksaw.

Remove any sharp edges with a file. Dimension F Cut length L mm Screw the rod firmly into place. Roughen the end of the cantilever rod and the inside of the cap to provide a key. Then apply two part epoxy adhesive to the rod end and the cap. The plug comes ready assembled and the socket can be mounted in the cockpit area adjacent to the tiller pilot.

Remove the template. Use a small flat-bladed screwdriver to connect the cable s to the socket — refer to the illustrations on the following pages. D 7. Assemble the rubber cap to one of the 4 self-tapping screws. The following table shows the minimum cable size acceptable for the power supply: Cable length Copper area AWG Up to 2.

Connect the SeaTalk cable to the tiller pilot socket as shown below. As well as sharing SeaTalk data, the tiller pilot can also be used to supply power to the SeaTalk instruments.

KODAK DX6490 MANUAL PDF

Handböcker

.

COURS 68HC11 PDF

Raymarine ST1000+ Manuals & User Guides

.

ALCINO SOUTINHO PDF

Käyttöoppaat

.

MASTERING THE BIZTALK TECHNICAL INTERVIEW PDF

Raymarine ST1000 & ST2000 Pinnenpiloten

.

Related Articles