DYNATEL 573A MANUAL PDF

Enable zoom About Trace Modes Peak: In this mode, as the antenna crosses the cable, the Receiver speaker volume increases to a maximum and the bar graph fills from both sides toward the middle. As the antenna moves off the cable path, the speaker volume decreases and the bar graph opens. Speaker response is cut off as the antenna moves away from the cable. Null: In this mode, the signal is a minimum directly over the cable and is maximum on either side of the cable. The speaker volume and display signal strength correspond to the signal being received. In the normal bar graph display mode Null flag flashing the bar graph opens at low signal strength and closes at high signal strength.

Author:Goran Akigis
Country:Lithuania
Language:English (Spanish)
Genre:Politics
Published (Last):4 September 2006
Pages:284
PDF File Size:20.70 Mb
ePub File Size:3.74 Mb
ISBN:618-7-95813-624-7
Downloads:72613
Price:Free* [*Free Regsitration Required]
Uploader:Kigagore



Enable zoom About Trace Modes Peak: In this mode, as the antenna crosses the cable, the Receiver speaker volume increases to a maximum and the bar graph fills from both sides toward the middle.

As the antenna moves off the cable path, the speaker volume decreases and the bar graph opens. Speaker response is cut off as the antenna moves away from the cable. Null: In this mode, the signal is a minimum directly over the cable and is maximum on either side of the cable. The speaker volume and display signal strength correspond to the signal being received. In the normal bar graph display mode Null flag flashing the bar graph opens at low signal strength and closes at high signal strength.

In the inverse Null bar graph display mode Null flag is on solid , the bar graph closes at low signal strength and opens at high signal strength. Differential: In this mode, the Receiver provides an indication of the relative position of the cable to the Receiver by displaying right or left arrows the arrow points toward the cable. The bar graph increases to a maximum as the Receiver antenna is moved directly over the cable path.

Speaker response is a high warbling tone to the right of the cable path, a low warbling tone to the left, and a solid tone directly over the cable. Special Peak Mode: This mode will increase the signal sensitivity of the Receiver when the signal is too weak for normal tracing. Use special attention when using this mode because it is more susceptible to congestion than the normal peak mode.

Numerical Signal Strength Display Resolution: The user may select between 3 levels of signal strength resolution. The setting will be displayed on the right end of the bar graph during selection. To change the setting, press and hold the key during power up then press the key.

Display resolution may be changed between the standard 1X, no bars illuminated , 2X, One bar illuminated , and 4X Two bars illuminated. The unit saves the last setting until changed. Note: While tracing cables in any mode, keep the Receiver handle in line with the suspected cable path. Page

M2N-VM DVI MANUAL PDF

3M Dynatel 2273 Advanced Cable and Fault Locator User Manual

.

CANDIDO POZO TEOLOGIA DEL MAS ALLA PDF

We Are Specialty Electronic System Integrators

.

Related Articles